DS Subsystem CLI access and commands
From Tecniq
Contents |
Password Access
- Password was "infiniti".
Later units use the IBM specific login and password of;
- ShellUsr
- wy3oo&w4
Network Access
To manage a storage subsystems through a firewall, configure the firewall to open port 2463 for TCP and UDP data.
netCfgSet and netCfgShow are the network setup commands for rlogin and serial command line.
Serial Access
For the serial connection, choose the correct port and the following settings:
- 57600 Baud
- 8 Data Bits
- 1 Stop Bit
- No Parity
- Xon/Xoff Flow Control
Send a break signal to the controller. This varies depending on the terminal emulation. For most terminal emulations, such as HyperTerm, which is included in Microsoft Windows products, press Ctrl+Break. If you only receive unreadable characters, press Ctrl+Break again, until the following message appears:
Press <SPACE> for baud rate within 5 seconds.
Press the Space bar to ensure the correct baud rate setting. If the baud rate was set, a confirmation appears. Press Ctrl+Break to log on to the controller. The following message appears:
Press within 5 seconds: <ESC> for SHELL, <BREAK> for baud rate.
Press the Esc key to access the controller shell. The password you are prompted for is infiniti. Note that this appears to have changed for the DS4700 and DS4800 systems and the serial connections are not longer directly supported.
Password Reset
To reset the storage manager password you need to log into each DS controller via the serial CLI and use the following command (case sensitive):
- clearSYMbolPassword
